User Manual

ManualsBrandsMetra ManualsAutomotiveMetra 99-7419 Single DIN Installation Kit for 2005-2006 Nissan Altima Vehicles without Navigation (Black)

INSTALLATION INSTRUCTIONS FOR PART 99-7419

Phillips Screwdriver • Small Flat Blade Screwdriver

1-800-221-0932 www.metraonline.com

KIT FEATURES

• DIN Head Unit Provision with Pocket

• ISO DIN Head Unit Provision with Pocket

• ( A) Radio Housing • ( B) Trim Plate • ( C) ISO Brackets

KIT COMPONENTS

TOOLS REQUIRED:

99-7419

APPLICATIONS

Nissan Altima

2005-2006

(Without factory navigation)

Summary of content (8 pages)

PAGE 1
INSTALLATION INSTRUCTIONS FOR PART 99-7419 APPLICATIONS Nissan Altima 2005-2006 (Without factory navigation) 99-7419 KIT FEATURES • DIN Head Unit Provision with Pocket • ISO DIN Head Unit Provision with Pocket KIT COMPONENTS • ( A) Radio Housing • ( B) Trim Plate • ( C) ISO Brackets A C B TOOLS REQUIRED: Phillips Screwdriver • Small Flat Blade Screwdriver 1-800-221-0932 www.metraonline.
PAGE 2
99-7419 TABLE OF CONTENTS Dash Disassembly 2005-2006 Nissan Altima . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Kit Assembly DIN Head Unit Provision with Pocket . . . . . . . . . . . . . . . . . . . . . . 2 ISO DIN Head Unit Provision with Pocket . . . . . . . . . . . . . . . . . . 3 Final Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PAGE 3
99-7419 DASH DISASSEMBLY 2005-2006 NISSAN ALTIMA A Disconnect the negative battery terminal to prevent an accidental short circuit. 1 2 Unclip and remove the trim panel surrounding the climate controls. (Figure A) 3 Remove (4) Phillips screws securing climate control and remove. (Figure B) 3 AUDIO 6 SCAN CLOCK CAT-RPT B Remove (4) Phillips screws securing radio to remove. (Figure D) 5 2 5 75 Unclip and remove the panel surrounding radio including A/C vents.
PAGE 4
99-7419 KIT ASSEMBLY 2005-2006 NISSAN ALTIMA DIN HEAD UNIT PROVISION A 1 Slide the DIN cage into the Radio Housing and secure by bending the metal locking tabs down. (Figure A) 2 Slide the after-market radio into the cage and secure.
PAGE 5
99-7419 KIT ASSEMBLY 2005-2006 NISSAN ALTIMA ISO DIN HEAD UNIT PROVISION A 1 Mount the ISO brackets to the radio with the screws supplied with the unit. (Figure A) 2 Slide the radio into the radio opening until the side clips engage. (Figure B) 3 Snap the 99-7419 trim plate into the radio housing.
PAGE 6
99-7419 FINAL ASSEMBLY FINAL ASSEMBLY 1 Locate the factory wiring harness in the dash and make the connection as shown. Metra recomends using the proper mating adapter and making the connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit.) 2 Re-connect the negative battery terminal and test the unit for proper operation. 3 Reassemble radio and dash assemblies in reverse order of disassembly.
PAGE 7
99-7419 NOTES 5