Owner's Manual

METRA. The World’s best kits.

™

metraonline.com

REV. 12/10/2015 INST99-7810B

CAUTION: Metra recommends disconnecting the negative battery

terminal before beginning any installation, unless the vehicle

manufacturer recommends against so. Please check with your

local Dealership for more information. All accessories, switches,

climate controls panels, and especially air bag indicator lights

must be connected before reconnecting the battery or cycling

the ignition. Also, do not remove the factory radio with the key

in the on position, or the vehicle running. It would be best to

remove the key from the ignition and then wait a few seconds

before removing the factory radio.

Installation instructions for part 99-7810B

• ISO DIN radio provision with pocket

• Painted matte black

• A) Radio trim panel • B) Radio trim panel brackets • C) Rear support bracket • D) Pocket

• E) (4) #8 x 3/8” Phillips screws • F) (8) #6 x 3/8” Phillips screws

20;-,(;<9,:

20;*64765,5;:

>0905.(5;,55(*655,*;065: (sold separately)

Wiring Harness: • 70-1729 Antenna Adapter: • 40-HD11

• Panel removal tool • Phillips screwdriver

• 8 mm socket wrench

;663:9,8<09,+

Honda HR-V 2016-up

99-7810B

Dash Disassembly ................................................. 2

Kit Assembly

– ISO DIN radio provision with pocket ...................... 3

Table of Contents

PAGE 1
Installation instructions for part 99-7810B Table of Contents Honda HR-V 2016-up 99-7810B Dash Disassembly ................................................. 2 Kit Assembly – ISO DIN radio provision with pocket...................... 3 REV.
PAGE 2
99-7810B Dash Disassembly 1. Open the glove box door. 2. Unclip and remove the trim panel surrounding the radio and a/c vent located to the left of the radio. (Figure A) 3. Remove (2) Phillips screws and (1) 8mm screw securing the factory radio, and then unplug and remove the radio.
PAGE 3
99-7810B Kit Assembly 1. Attach the radio trim panel brackets to the radio trim panel using (4) #6 x 3/8” Phillips screws supplied. (Figure A) 5. Slide the radio into the completed assembly, and then secure it to the assembly using the screws supplied with the radio. (Figure D) 2. Attach the rear support bracket to the radio trim panel brackets using (4) #6 x 3/8” Phillips screws supplied. (Figure B) 6.
PAGE 4
Installation instructions for part 99-7810B IMPORTANT If you are having difficulties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated. Please have the vehicle apart and ready to perform troubleshooting steps before calling. KNOWLEDGE IS POWER REV.