Owner's Manual

Installation Kit

120 99-7890

Honda

1. Secure bottom mounting plate to receiver mounting bracket using keps nuts and

carriage bolts supplied with kit (Figure 1).

2. Break off clips on upper sides (not needed for this application) with pliers (Figure 2).

3. Drill a starter hole where shown in bottom mounting plate and secure rear support strap to

the plate using the truss head screw supplied with kit (Figure 3).

Kit Preparation

Keps Nuts

Receiver Mounting Bracket

Clips

Tools Required

▲

Pliers

Deep Socket

(size depends upon

receiver)

FIGURE 1

FIGURE 2

FIGURE 3

Drill and Bit

Phillips

Screwdriver

Bottom Mounting Plate

Carriage Bolts

Rear Support Strap

Truss Head Screw

See page 3 for DIN assembly or

page 4 for shaft receiver

assembly instructions.