Owner's Manual

Installation Kit
Tools Required
120 99-7890
▲
Phillips
Screwdriver
Honda
DIN Receiver Assembly
3
Flat Blade
Screwdriver
Rear Support Strap
1. Remove DIN sleeve from receiver.
2. Slide DIN sleeve into opening in
receiver mounting bracket.
3. Secure DIN sleeve to bracket by bending
the securing tabs as shown (Figure 1).
4. Slide receiver fully into DIN sleeve.
5. Bend rear support strap upward and
secure to rear of receiver with hardware
supplied with receiver (Figure 2).
6. If not installing an equalizer, snap
EQ cover plate into lower opening
in mounting bracket.
DIN Sleeve
Securing Tabs
FIGURE 1
FIGURE 2
®
Copyright 1999 Crutchfield Corporation
(Bend tabs after sleeve
is inside mounting bracket)
Adjustable
Wrench
Receiver Mounting Bracket
EQ Cover Plate