User Manual

®
5.6
Honda Odyssey 1995-1998,
Isuzu Oasis 1996-1999
1. Remove (2) 8mm screws under the glove box.
2. Remove (1) Phillips screw on the glove box arm and
remove the box.
3. Remove (2) Phillips screws exposed in the glove
box cavity.
4. Remove (2) Phillips screws below the storage box door
(under the ashtray).
5. Remove (2) screws from the left side of the dash
console. Remove (1) Phillips screw from the coin tray.
6. Remove (1) Phillips screw under the ignition. Remove
(4) Phillips screws securing the factory cupholder.
7. Remove (2) 8mm hex-head screws from the rear
support bracket and disconnect the wiring.
8. Cut and remove the top clips from the radio housing.
For ISO DIN radio provisions: Secure the rear support
bracket to the back of the pocket with (2) Phillips
screws supplied. (Figure C)
Continue to kit assembly for ALL VEHICLES, Section 5
All Vehicles
2-shaft radio provision with pocket:
1. Snap the faceplate into the radio housing. (Figure A)
2 Slide the radio into the kit and secure with shaft
nuts. (Figure A)
Continue on the next page, Step 4
(Figure C)(Figure C)
(Figure A)
(Figure B)
Dash Disassembly Kit Assembly
99-7892