User Manual

ManualsBrandsMetra ManualsAutomotiveMETRA Ltd 99-8140 91 - 95 Toyota Truck Radio Install Kit

Re-connect the battery terminal and test the unit

for proper operation. Mount the head unit/kit

assembly to the sub-dash with (4) screws

previously removed in step #1. (For the Standard

Cab Pickup 1992-95, slide the lower mounting

tabs behind the dash bracket and secure from

behind ("A"). (see Fig. A)

Locate the factory wiring harness in the

dash. Metra recommends using the

proper mating adaptor and making

connections as shown. (Isolate and

individually tape off the ends of any

unused wires to prevent electrical short

circuit).

A) Strip wire ends back ½"

B) Twist ends together

C) Solder

D) Tape

99-8140

INSTALLATION

INSTRUCTIONS

APPLICATIONS

CAR PAGE

TOYOTA

4-Runner 1990-95..................................................... 1

4-Runner 1989-2002...................................................2

Pickup (standard cab) 1989-2002.................................1

Pickup (extended cab) 1989-2002................................1

T-100 1993-98.............................................................1

Tacoma 1995-01..........................................................2

KIT COMPONENTS

TOOLS REQUIRED

Cutting tool

Socket wrench

Phillips screwdriver

Faceplate

Equalizer

Dummy

Plate

KIT FEATURES

Shaft and

DIN unit

provisions

Equalizer

provisions

Radio Housing

2-SHAFT HEAD UNITS: Attach the Faceplate to the Radio Housing. Slide the aftermarket

head unit into the kit and secure with shaft nuts. (see Fig. A)

DIN HEAD UNITS: Cut and remove the shaft supports from the Radio Housing. Slide the

DIN cage into the kit and secure by bending the metal locking tabs down. Slide the aftermarket

head unit into the cage until secure. (see Fig. B)

(If an equalizer will be included, slide the unit into the back of the Radio Housing and secure.

If an equalizer will NOT be included, snap the Equalizer Dummy Plate into the opening).

ALL VEHICLES

Fig. B

Fig. A

"A"

1-800-221-0932 www.metraonline.com

rev. 201202

Summary of content (2 pages)

PAGE 1
KIT FEATURES ALL VEHICLES Shaft and DIN unit provisions 3 Equalizer provisions Fig. A Fig. B 2-SHAFT HEAD UNITS: Attach the Faceplate to the Radio Housing. Slide the aftermarket head unit into the kit and secure with shaft nuts. (see Fig. A) DIN HEAD UNITS: Cut and remove the shaft supports from the Radio Housing. Slide the DIN cage into the kit and secure by bending the metal locking tabs down. Slide the aftermarket head unit into the cage until secure. (see Fig.
PAGE 2
TOYOTA 4-Runner 1989-2002 TOYOTA 4-Runner 1990-95 Pickup (standard cab) 1989-2002 / Pickup (extended cab) 1989-2002 1 1 2 2 Fig. A Fig. B Disconnect the negative battery terminal to prevent an accidental short circuit. Remove (3) screws and (1) 10mm bolt from the driver's side speaker panel and remove the panel. Remove (1) 10mm bolt from the bottom of the passenger's side speaker panel. Remove (3) screws from the side of the panel and remove the glove box.