User Manual

Kit Assembly 99-8218
1. Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adapter from Metra or
AXXESS. Re-connect the negative
battery terminal and test the unit for
proper operation.
2. Cut and remove center divider from
radio housing. (Figure A)
3. Snap the Double DIN brackets to the
inside edge of the radio housing.
(Figure B)
4. Slide the Stacked ISO units into the
Double DIN bracket/radio housing
assembly and secure the radio to the
assembly using the screws supplied
with the units. (Figure C)
5. Snap the Double DIN trim-plate into the
housing/radio assembly. (Figure C)
Continued on next page
Stacked ISO units provision
(Figure C)
11
(Figure A)
(Figure B)