Owner's Manual

1.800.221.0932
|
MetraOnline.com
6
KIT ASSEMBLY
ISO DDIN radio provision
1. Cut and remove the center bar from the
radio housing. (Figure A)
2. Snap the ISO DDIN radio brackets to
the inside edge of the radio housing.
(Figure B)
3. Slide the radio into the bracket/radio
housing assembly and secure using
screws supplied with the radio. (Figure C)
4. Snap the ISO DDIN trim plate onto the
front of the radio/housing assembly.
(Figure C)
5. Locate the factory wiring harness and
antenna connector in the dash. Metra
recommends using the proper mating
adapter from Metra or AXXESS. Test the
radio for proper operation.
6. Reassemble the dash in reverse order of
disassembly to complete the installation.
(Figure A) (Figure C)(Figure B)