User Manual

ManualsBrandsMetra ManualsAutomotiveMetra 99-8901 Single DIN Installation Kit for 2005-2007 Subaru Legacy (Excluding Outback Sport)

INSTALLATION INSTRUCTIONS FOR PART 99-8901

1-800-221-0932 www.metraonline.com

KIT FEATURES

• DIN head unit provision with a pocket

• ISO DIN head unit provision with a pocket

A) Radio Housing • B) Radio Housing Brackets • C) ISO Brackets • D) Trim Plate

KIT COMPONENTS

TOOLS REQUIRED:

99-8901

APPLICATIONS

Subaru Legacy/Outback

For Manual Climate Controls Only

(Excluding Outback Sport)

2005-2009

Phillips Screwdriver • Small Flat Blade Screwdriver • Socket Wrench

WIRING AND ANTENNA CONNECTIONS (Sold Separately)

Wire harness:

• 70-8901 Subaru harness 1990-up

Antenna adapter:

• 40-SB10 Subaru antenna adapter 2005-up

Summary of content (8 pages)

PAGE 1
INSTALLATION INSTRUCTIONS FOR PART 99-8901 APPLICATIONS Subaru Legacy/Outback For Manual Climate Controls Only (Excluding Outback Sport) 2005-2009 99-8901 KIT FEATURES • DIN head unit provision with a pocket • ISO DIN head unit provision with a pocket KIT COMPONENTS A) Radio Housing • B) Radio Housing Brackets • C) ISO Brackets • D) Trim Plate A B C WIRING AND ANTENNA CONNECTIONS (Sold Separately) Wire harness: • 70-8901 Subaru harness 1990-up Antenna adapter: • 40-SB10 Subaru antenna adapter 2005-up
PAGE 2
99-8901 TABLE OF CONTENTS Dash Disassembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Kit Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2, 3, 4 Final Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 KNOWLEDGE IS POWER Enhance your installation and fabrication skills by enrolling in the most recognized and respected mobile electronics school in our industry. Log onto www.installerinstitute.
PAGE 3
99-8901 DASH DISASSEMBLY SUBARU LEGACY AND OUTBACK EXCLUDING OUTBACK SPORT 2005-2009 A 1 Disconnect the negative battery terminal to prevent an accidental short circuit. 2 Unclip and remove panel surrounding shifter including ashtray. (Figure A) 3 Remove (1) Phillips screw per side panel then unclip and remove panels. (Figure B) B 4 Remove (6) Phillips from radio to remove.
PAGE 4
99-8901 KIT ASSEMBLY SUBARU LEGACY AND OUTBACK EXCLUDING OUTBACK SPORT 2005-2009 A Side View 1 Clip the climate control into the back of the 99-8901. (Figure A) 2 Attach the corresponding bracket to the back of the pocket and secure with the provided Phillips screws. (Figure B) Side Clip B Phillips Screws Rear View C Side View Bracket 3 Secure the climate control to the brackets using the factory screws.
PAGE 5
99-8901 KIT ASSEMBLY DIN HEAD UNIT PROVISION A 1 Slide the DIN cage into the Radio Housing and secure by bending the metal locking tabs down. (Figure A) 2 Slide the aftermarket head unit into the cage and secure.
PAGE 6
99-8901 KIT ASSEMBLY ISO DIN HEAD UNIT PROVISION A 1 Mount the ISO Brackets to the head unit with the screws supplied with the unit. (Figure A) 2 Slide the head unit into the radio opening until the side clips engage. (Figure B) 3 Snap the Trim plate into the Radio Housing.
PAGE 7
99-8901 FINAL ASSEMBLY FINAL ASSEMBLY 1 Locate the factory wiring harness in the dash and make the connection as shown. Metra recomends using the proper mating adapter and making the connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit.) 2 Re-connect the negative battery terminal and test the unit for proper operation. 3 Reassemble radio and dash assemblies in reverse order of disassembly.
PAGE 8
99-8901 INSTRUCTIONS 1-800-221-0932 REV. 05/15/09 www.metraonline.