Owner's Manual

ManualsBrandsMetra ManualsAudio accessories & installationDash Kit

CAUTION!

All accessories, switches, climate

controls panels, and especially air bag indicator

lights must be connected before cycling the

ignition. Also, do not remove the factory radio

with the key in the on position, or while the

vehicle is running.

The World’s best kits.





INSTALLATION INSTRUCTIONS

99-8908HG

KIT FEATURES

• ISO DIN radio provision with pocket

• Painted high gloss black

KIT COMPONENTS

• A) Radio housing trim panel • B) Radio brackets • C) Shallow pocket • D) Pocket • E) (4) Panel clips • F) (8) #8 x 3/8” Phillips screws

TOOLS REQUIRED

• Panel removal tool • Phillips screwdriver

TABLE OF CONTENTS

Dash Disassembly ..................................................2

Kit Preparation .......................................................2

Kit Assembly ..........................................................3

WIRING & ANTENNA CONNECTIONS

(sold separately)

Wiring Harness: 70-1761

Antenna Adapter: 40-LX11

A B C

Subaru Impreza 2017-up

*Visit MetraOnline.com for up-to-date vehicle speciﬁc applications.

Summary of content (4 pages)

PAGE 1
99-8908HG I N S TA L L AT I O N I N S T R U C T I O N S Subaru Impreza 2017-up *Visit MetraOnline.com for up-to-date vehicle speciﬁc applications. KIT FEATURES • ISO DIN radio provision with pocket • Painted high gloss black KIT COMPONENTS • A) Radio housing trim panel • B) Radio brackets • C) Shallow pocket • D) Pocket • E) (4) Panel clips • F) (8) #8 x 3/8” Phillips screws A B C E The World’s best kits. MetraOnline.
PAGE 2
DASH DISASSEMBLY 1. Attach the shallow pocket to the radio housing trim panel using (4) #8 x 3/8” Phillips screws provided. (Figure A) 1. Unclip and remove the a/c vents on each side of the factory radio. (Figure A) 2. Unclip and remove the trim panel on top of the factory radio. (Figure B) 3. Remove (4) Phillips screws securing the radio, then unclip and remove it. (Figure C) KIT PREPARATION 2. Attach the (4) panel clips to the radio housing trim panel.
PAGE 3
KIT ASSEMBLY ISO DIN radio provision with pocket 1. Attach the pocket to the radio brackets using (4) of the supplied #8 x 3/8” Phillips screws. (Figure A) 2. Remove the metal DIN sleeve and trim ring from the aftermarket radio. 3. Slide the radio into the completed assembly, and then secure it to the assembly using screws supplied with the radio. (Figure B) 4. Locate the factory wiring harness and antenna plug in the dash and make all necessary wire connections to the radio.
PAGE 4
99-8908HG I N S TA L L AT I O N I N S T R U C T I O N S IMPORTANT If you are having difﬁculties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated. Please have the vehicle apart and ready to perform troubleshooting steps before calling.