Owner's Manual

REV. 7/12/2017 INST99-8908HG
3
ISO DIN radio provision with pocket
1. Attach the pocket to the radio brackets
using (4) of the supplied #8 x 3/8”
Phillips screws. (Figure A)
2. Remove the metal DIN sleeve and trim
ring from the aftermarket radio.
3. Slide the radio into the completed
assembly, and then secure it to the
assembly using screws supplied with
the radio. (Figure B)
4. Locate the factory wiring harness and
antenna plug in the dash and make all
necessary wire connections to the radio.
Metra recommends using the proper
mating adapters from Metra and/or
AXXESS.
5. Secure the completed assembly into the
sub-dash using the factory hardware.
6. Snap the
radio housing trim panel over
the completed assembly, and then
reassemble the dash in reverse order
of disassembly.
KIT ASSEMBLY
(Figure A) (Figure B)