Quick Start Guide

99-9605B
7
Kit Assembly
ISO DDIN radio provision
1. Slide the radio into the radio
housing and then secure it using
the screws supplied with the radio.
(Figure A)
2. Slide the radio housing into the
radio frame assembly removed in
dash dissassembly. (Figure B)
3. Locate the factory wiring harness
and antenna connector in the
dash and complete all necessary
connections to the radio and HVAC
controls. Metra recommends using
the proper mating adapter from
Metra and/or AXXESS. Test the
radio for proper operation.
4. Place the radio brackets around
the radio housing assembly and
then secure it using the (2) 8 x 3/8”
Phillips screws provided.
(Figure C)
5. Reassemble the upper dash in
reverse order of disassembly.
For models without factory
navigation:
1. Secure the HVAC controls into the
lower location of the lower console
using the screws removed in dash
disassembly. (Figure A)
2. Snap the climate trim panel with
pocket into the lower console
location. (Figure B)
3. Reassemble the lower dash in
reverse order of disassembly.
(Figure B)
(Figure A)
(Figure A)
(Figure C)
(Figure B)