Manualshelf

Installation Guide

ManualsBrandsMetra ManualsAudioRadio Housing Car Kit
12
TOOLS REQUIRED
Socket wrench
Phillips screwdriver
KIT COMPONENTS
99-3301
INSTALLATION
INSTRUCTIONS
APPLICATIONS
CAR PAGE
BUICK
LeSabre 2000.............................................................. 1
CHEVROLET
Cavalier 2000..............................................................1
Impala 2000................................................................1
Monte Carlo 2000........................................................ 1
Venture 2000...............................................................2
OLDMOBILE
Silhouette 2000........................................................... 2
PONTIAC
Bonneville 2000...........................................................2
Montana 2000.............................................................2
Sunfire 2000............................................................... 2
Mounting
Brackets
KIT FEATURES
ISO-DIN unit
provisions
CD pocket holds
(2) jewel cases
Radio Housing
1-800-221-0932 www.metraonline.com
© COPYRIGHT 2001 METRA ELECTRONICS CORPORATION
Disconnect the negative battery terminal to prevent an
accidental short circuit. Remove (3) 7mm hex-head
screws from the top of the glove box liner. Remove (2)
7mm hex-head screws from the top-left corner of the glove
box cavity. Remove (1) Phillips screw from the defroster
duct. Remove the duct work and (1) Phillips screw
exposed. Unclip the dash trim piece and remove (2)
Phillips screws exposed. Remove the dash pad and (3)
Phillips screws exposed at the top of the radio trim bezel.
Skip to the Installation Instructions for ALL VEHICLES on
Page #3.
Disconnect the negative battery terminal to prevent an
accidental short circuit. Open the glove box and remove
(2) Phillips screws exposed. Unclip and remove the
climate control trim bezel. Unclip the light control trim
bezel and remove. Remove (1) 9/32" behind the steering
column shifter. Remove (1) 9/32" from the right side of the
factory radio trim bezel and remove the bezel. Depress
the spring clips on each side of the factory head unit and
remove. Skip to the Installation Instructions for ALL
VEHICLES on Page #3.
Disconnect the negative battery terminal to prevent an
accidental short circuit. Unclip the trim panel above the
pedals. (It is NOT necessary to remove the panel, it may
be left hanging). Remove (2) 9/32" screws from the knee
panel and unclip the panel. Unsnap the driver's side fuse
panel cover and remove (1) 9/32" screw. Open the glove
box and remove (1) 9/32" screw from the upper left corner.
Remove (3) 9/32" screws securing the factory radio and
disconnect the wiring. Skip to the Installation Instructions
for ALL VEHICLES on Page #3.
Disconnect the negative battery terminal to prevent an
accidental short circuit. Unclip each side of the dash trim
bezel (fuse access) and remove (1) Phillips screw exposed
on each side. Remove (2) Phillips screws under the
instrument cluster. Unclip the trim panel above the pedals.
(It is not necessary to remove the panel, it can be left
hanging). Remove (2) Phillips screws from the knee panel.
Unclip the knee panel and remove (1) Phillips screw
exposed on the right side of the steering column. Unclip and
remove the entire dash trim bezel. Skip to the Installation
Instructions for ALL VEHICLES on Page #3.
1
1
1
1
CHEVROLET Cavalier 2000
BUICK LeSabre 2000
CHEVROLET Monte Carlo 2000
CHEVROLET Impala 2000
1

Summary of content (2 pages)