Installation Guide

ManualsBrandsMetra ManualsAudioMetra Stereo Installation Kit

1-800-221-0932 • www.metraonline.com

INSTALLATION INSTRUCTIONS

Nissan 350Z 2003

VEHICLE APPLICATIONS

•

Phillips screw

driver

• Utility knife

• DIN head unit

provision with pocket

• ISO head unit

provision with pocket

•

Stacked ISO head

unit provision

• Double DIN head

unit provision

99-7402

Questions?

Call the Help Line:

(800)253 TECH

INST997402

rev. 221102

Housing

with

Pocket

Double DIN

Tr implate

KIT COMPONENTS

ISO

Tr implate

ISO Spacer

Brackets (2)

ISO Snap-in

Brackets (2)

TOOLS REQUIREDKIT FEATURES

Summary of content (5 pages)

PAGE 1
99-7402 KIT COMPONENTS Housing with Pocket Nissan 350Z 2003 Double DIN Trimplate ISO Trimplate • KIT FEATURES TOOLS REQUIRED DIN head unit • Phillips screw driver • Utility knife provision with pocket • ISO head unit provision with pocket • Stacked ISO head unit provision • Double DIN head unit provision ISO Spacer Brackets (2) INSTALLATION INSTRUCTIONS VEHICLE APPLICATIONS ISO Snap-in Brackets (2) Questions? Call the Help Line: (800)253 TECH INST997402 rev.
PAGE 2
99-7402 99-7402 99-7402 • Nissan 350Z 2003 • • • • DIN Head Unit Provision with Pocket Assembly Double DIN Head Unit Provision Assembly ISO Head Unit Provision with Pocket Assembly Stacked ISO Head Unit Provision Assembly • Final Assembly 1 1 Disconnect the negative battery terminal to prevent an accidental short circuit. 2 3 4 5 2 For vehicles with automatic transmission, remove smaller trim ring from around shift selector.
PAGE 3
99-7402 99-7402 99-7402 • Nissan 350Z 2003 1 Attach the single DIN Housing to the bezel, using the factory screws. See figure A B 2 Reattach bezel/housing assembly to the dash and secure upper mounting positions using factory screws. (Please refer to dash disassembly.) 3 Slide DIN cage into the housing and secure by bending metal locking tabs outward. See figure B 4 Skip to Step #1 in the Final Assembly on page 6 and return to complete step 5 below.
PAGE 4
99-7402 99-7402 99-7402 • Nissan 350Z 2003 1 Attach the single DIN Housing to the bezel, using the factory screws. See figure A 2 Reattach bezel/housing assembly to the dash and secure upper mounting positions using factory screws. (Reverse order of disassembly.) 3 Align the holes in the ISO Snap-in Brackets with the holes in the head unit. B Place the Double DIN Trimplate onto the left factory bracket using the alignment pins.
PAGE 5
99-7402 99-7402 • Nissan 350Z 2003 FINAL ASSEMBLY A A) Strip wire ends back 1/2" B) Twist ends together C) Solder D) Tape 1 Locate the factory wiring harness in the dash. Metra recommends using the proper mating adapter and making connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit). See figure A 6 2 Re-connect the battery terminal and test the unit for proper operation.