Installation Instructions

REV. 10/18/2018 INST99-7527S
7
ISO DDIN radio provision
1. Cut and remove the center bar from the
radio housing. (Figure A)
2. Snap the double DIN brackets to the
inside edge of the radio housing .
(Figure B)
3. Slide the radio into the bracket/radio
housing assembly, then secure the
radio to the assembly using the screws
supplied with the radio. (Figure C)
4. Snap the double DIN trim plate onto the
front of the radio housing . (Figure C)
KIT ASSEMBLY
5. Locate the factory wiring harness and
connector in the dash and complete
all necessary connections to the radio.
Metra recommends using the proper
mating adapter from Metra and/or
Axxess. Test the radio for
proper operation.
6. Reassemble the dash in the reverse
order of disassembly using the 99-7527S
radio housing assembly to complete
the installation.
(Figure B)
(Figure A) (Figure C)
Remove
shaded
area