TurboTouch Technical Document

Steering Wheel Controls With

New JVC & Kenwood Radios

1. Locate the main connector on the back of the radio. These radios use an ISO/EURO (1784 shell) radio

connector. (Figure A)

2. The SWC wire from the radio can be found in the bundle of wires above the main connector, labeled

REMOTE CONT. (Figure B)

3. Program the kit, then refer to the Select Radio page from the instructions included with the kit.

4. Select JVC for the desired radio.

Note: Regardless if it is a JVC or Kenwood radio, the desired radio code will be JVC.

5. Test the steering wheel controls for proper functionality.

6. The installation is now complete.

(Figure A)

(Figure B)

TURBOTOUCH Technical Document #100C

AxxessInterfaces.com