Installation Guide

KIT COMPONENTS
TOOLS REQUIRED
Cutting tool
Socket wrench
Phillips screwdriver
KIT FEATURES
ISO and DIN
head unit
provisions
Pocket
provisions
99-8202
INSTALLA TION
INSTRUCTIONS
APPLICATIONS
CAR PAGE
TOYOTA
Celica 2000-05.................................................. 1
Echo 2000-05.................................................... 1
MR2 Spyder 2000-05........................................ 2
RAV-4 2001-05................................................. 2
Re-connect the battery terminal and test the unit
for proper operation. Mount the head unit/kit
assembly to the sub-dash with (4) screws
previously removed in step #1.
5 4
Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adaptor and making
connections as shown. (Isolate and
individually tape off the ends of any
unused wires to prevent electrical short
circuit).
A
B
C
D
A) Strip wire ends back ½"
B) Twist ends together
C) Solder
D) Tape
3
1-800-221-0932 www.metraonline.com
© COPYRIGHT 2001-07 METRA ELECTRONICS CORPORATION
rev. 06-15-07
ALL VEHICLES
3
ISO HEAD UNITS: Slide the Mounting Brackets onto the sides of the Radio Housing until the side
clips engage. Mount the ISO Brackets to the head unit with the screws supplied with the unit. Slide
the head unit into the radio opening until the side clips engage. Snap the Trimplate into the Radio
Housing. (see Fig. A).
DIN HEAD UNITS: Slide the Mounting Brackets onto the sides of the Radio Housing until the side
clips engage. Slide the DIN cage into the Housing and secure by bending the metal locking tabs
down. Slide the aftermarket head unit into the cage and secure. Snap the *Trimplate into the Radio
Housing. (see Fig. B)
Fig. B
* OPTIONAL
Fig. A
Mounting
Brackets
Radio
Housing
ISO
Brackets
Trimplate
PA TENT
PENDING
PA TENT
PENDING