Owner's Manual

ManualsBrandsMetra ManualsAudioMetra Toyota C-HR 2018 Dash Kit

CAUTION!

All accessories, switches, climate

controls panels, and especially air bag indicator

lights must be connected before cycling the

ignition. Also, do not remove the factory radio

with the key in the on position, or while the

vehicle is running.

The World’s best kits.



INSTALLATION INSTRUCTIONS

99-8265HG

KIT FEATURES

• ISO DIN radio provision with pocket

• Painted high gloss black

KIT COMPONENTS

• A) Radio housing trim panel • B) Radio brackets • C) Pocket • D) (4) #6 x 3/8” Phillips screws • D) (2) #8 x 3/8” Phillips screws

TOOLS REQUIRED

• Panel removal tool • Phillips screwdriver

• 10mm socket wrench

TABLE OF CONTENTS

Dash Disassembly ..................................................2

Kit Assembly

- ISO DIN radio provision with pocket ..................3

WIRING & ANTENNA CONNECTIONS

(sold separately)

Wiring Harness: 70-1761

Antenna Adapter: 40-LX10

A B C D E

Toyota C-HR 2018-up*

*Visit MetraOnline.com for up-to-date vehicle speciﬁc applications.

Summary of content (4 pages)

PAGE 1
99-8265HG I N S TA L L AT I O N I N S T R U C T I O N S Toyota C-HR 2018-up* TABLE OF CONTENTS Dash Disassembly...................................................2 Kit Assembly - ISO DIN radio provision with pocket...................3 *Visit MetraOnline.com for up-to-date vehicle specific applications.
PAGE 2
DASH DISASSEMBLY 1. Unclip and remove the trim panel from around the factory radio, including the clock. (Figure A) 2. Remove (4) 10mm bolts securing the radio, then remove it. (Figure B) Continue to Kit Assembly (Figure B) (Figure A) 2 1.800.221.0932 | MetraOnline.
PAGE 3
KIT ASSEMBLY ISO DIN radio provision with pocket 5. Locate the factory wiring harness and antenna plug in the dash and make all necessary wire connections to the radio. Metra recommends using the proper mating adapters from Metra and/ or AXXESS. Test the radio for proper operation. 1. Attach the radio brackets to the radio housing trim panel using the (4) #6 x 3/8” screws supplied. (Figure A) 2. Mount the pocket to the radio brackets with the (2) #8 x 3/8” Phillips screws supplied. (Figure B) 6.
PAGE 4
99-8265HG I N S TA L L AT I O N I N S T R U C T I O N S IMPORTANT If you are having difficulties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated. Please have the vehicle apart and ready to perform troubleshooting steps before calling.