Installation

ManualsBrandsMetra ManualsMobile Power AccessoriesMetra 12-Volt To 6-Volt Camera Stepdown

Installation Instructions for AX-CAM6V

REV. 9/1/2015 INSTAX-CAM6V

axxessinterfaces.com

•

metraonline.com

Axxess Integrate

AX-CAM6V

12-volt to 6-volt Step-Down Converter

CONNECTIONS TO BE MADE

• Connect the Black wire to ground.

• Connect the Blue/White wire to the 12-volt reverse wire.

• Connect the Blue/Red wire to the factory camera power wire.

INTERFACE COMPONENTS

• AX-CAM6V converter/harness with stripped leads

TOOLS REQUIRED

• Cutting tool • Tape • Crimping tool

• Connectors (i.e. butt-connectors, bell caps, etc.)

FEATURES

• Converts 12-volts DC to 6-volts DC to provide proper voltage

for a 6-volt factory backup camera.

CAUTION!

Metra recommends disconnecting the negative battery terminal before beginning any installa

tion, unless the vehicle manufacturer recommends against so. Please check with your local Dealership for

more information. All accessories, switches, climate controls panels, and especially air bag indicator lights

must be connected before reconnecting the battery or cycling the ignition. Also, do not remove the factory

radio with the key in the on position, or the vehicle running. It would be best to remove the key from the

ignition and then wait a few seconds before removing the factory radio.

Summary of content (4 pages)

PAGE 1
Installation Instructions for AX-CAM6V AX-CAM6V 12-volt to 6-volt Step-Down Converter CAUTION! Metra recommends disconnecting the negative battery terminal before beginning any installation, unless the vehicle manufacturer recommends against so. Please check with your local Dealership for more information. All accessories, switches, climate controls panels, and especially air bag indicator lights must be connected before reconnecting the battery or cycling the ignition.
PAGE 2
AX-CAM6V IMPORTANT REV. 9/1/2015 INSTAX-CAM6V If you are having difficulties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated. Please have the vehicle apart and ready to perform troubleshooting steps before calling.
PAGE 3
Instrucciones de instalación para AX-CAM6V AX-CAM6V 12-voltios a 6-voltios Convertidor Descender CARACTERÍSTICAS • Convierte 12-voltios DC a 6-voltios DC para proporcionar el voltaje adecuado para una cámara de seguridad de la fábrica de 6-voltios ¡PRECAUCIÓN! Meta recomienda desconectar la terminal negativa de la batería antes de iniciar cualquier instalación, a menos que el fabricante del vehículo recomiende lo contrario. Verifique con su concesionario local si existe más información.
PAGE 4
AX-CAM6V IMPORTANTE REV. 9/1/2015 INSTAX-CAM6V Si tiene dificultades con la instalación de este producto, llame a nuestra línea de soporte técnico al 1-800-253-TECH. Antes de hacerlo, revise las instrucciones por segunda vez y asegúrese de que la instalación se haya realizado exactamente como se indica en las instrucciones. Por favor tenga el vehículo desarmado y listo para ejecutar los pasos de resolución de problemas antes de llamar.