Installation Guide

3
REV. 7/30/2019 INSTAXTC-CH5
Open the driver’s door, and keep open during the programming process.
Cycle the ignition on.
Connect the AXTC-CH5 harness to the AXTC-CH5 interface, and then to
the wiring harness in the vehicle.
Locate the Volume Up button behind the steering wheel on the right
hand side. Program the interface by tapping the Volume Up button at
a heartbeat pace until the LED light stops flashing. For models with just
Bluetooth buttons on the steering wheel, use the PTT button instead.
The LED light will flash Green & Red while the interface programs
the radio to the steering wheel controls. Once programmed, the
LED light will go out, then produce a pattern which will identify the
radio type installed. Refer to the Radio LED Feedback section under
Troubleshooting for radio types.
The LED light will go out, then once again quickly flash Green & Red
while the interface programs itself to the vehicle. Once programmed,
the LED light will go out again, then turn solid Green.
Cycle the ignition off, then back on.
Test all functions of the installation for proper operation.
PROGRAMMING
1.
2.
3.
4.
5.
6.
7.
8.
Green & Red LED
Green LED
O
F
F
A
C
C
O
N
S
T
A
R
T
O
F
F
A
C
C
O
N
S
T
A
R
T
O
F
F
A
C
C
O
N
S
T
A
R
T
Green & Red LED
Green or Red LED