Installation Instructions

2
CONNECTIONS
From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the Blue/White wire to the amplifier turn on wire. This wire must be connected to
hear sound from the factory amplifier.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative output.
• Tape off and disregard the following (6) wires, they will not be used in this application:
Blue/Pink, Brown, Green/Purple, Light Green, Orange/White, Red
From the AXTO-TY3 harness to the aftermarket radio:
• Connect the Black wire to the ground wire. There will also be a ground wire from the backup
camera harness to connect as well.
• Connect the Yellow wire to the battery wire.
• Connect the Red wire to the accessory wire.
• Connect the Green/Purple wire to the reverse wire, and also to the Blue/White wire from
the AXCSD-6V.
The following (1) wire is only for a multimedia/navigation radio that requires this wire.
• Connect the Blue/Pink wire to the VSS/speed sense wire.
• Connect the Red and White RCA jacks to the audio AUX-IN jacks from the aftermarket radio.
12-pin AXSWC harness & 3.5mm jack:
The 12-pin AXSWC harness & 3.5mm jack is to be used with the AXSWC (sold separately)
to retain steering wheel audio controls. If the AXSWC is not being used, disregard this
harness. If it is to be used, please refer to the AXSWC instructions for radio connections and
programming. Disregard the harness that comes with the AXSWC.
Backup camera harness:
• Connect the Black wire labeled “CAMERA GROUND”, to the ground from the AXTO-TY3
harness, and also to the Black wire from the AXCSD-6V.
• Connect the Red wire labeled “CAMERA POWER 6V”, to the Blue/Red wire from
the AXCSD-6V.
• Connect the Yellow RCA jack labeled “BACKUP CAMERA”, to the radios backup camera input.
The following (1) wire is only for a multimedia/navigation radio that requires this wire.
• Connect the Light Green wire to the radios parking brake wire.