Installation Instructions

3
REV. 3/24/2020 INSTAXTO-TY3
With the key in the off position:
1. Connect the 16-pin harness with stripped leads, and the AXTO-TY3 harness, into the
AXTO-TY3 interface.
2. Connect the backup camera harness, and the AXTO-TY3 harness, to the wiring harness in
the vehicle.
3. If an AXSWC (sold separately) will be used, do not connect it until the AXTO-TY3 is
programmed and fully functional.
Attention! If the interface ever loses power, the following steps will need to be performed again.
Please ensure that the owner of the vehicle knows this.
1. Turn the key (or push-to-start button) to the ignition position and wait until the radio comes
on.
Note: If the radio doesn’t not come on within 60 seconds, turn the key to the off position,
disconnect the interface, check all connections, reconnect the interface, and then try again.
2. Cycle the key off, then back on. If the driver’s door is closed, open and close the door.
3. Test all functions of the installation for proper operation, before reassembling the dash.
Note: To use fade, ensure that the radio is turned up 3/4 of the way. Also note that the fader
will not entirely cut out the speakers.
1.
With the vehicle and radio turned on, turn the volume up 3/4 of the way.
2. With a small flat-blade screwdriver, adjust the potentiometer clockwise to raise the audio
level; counterclockwise to lower the audio level.
3. Once at a desired level, audio level adjustment is complete.
I N STALL ATION
PROGRAMMING
AUDIO LEVEL ADJUSTMENT