Installation instructions

ManualsBrandsMetra ManualsMobile PhonesDash kit

METRA. THE WORLD’S BEST KITS.™

APPLICATIONS

1-800-221-0932

metraonline.com

INSTALLATION INSTRUCTIONS FOR PART 99-7611

WIRING & ANTENNA CONNECTIONS (Sold Separately)

Wiring Harness:

• 70-7552 - Nissan harness 2010-up

Antenna Adapter:

• 40-NI12 - Nissan antenna adapter 2010-up

Panel Removal Tool • Phillips Screwdriver • Socket Wrench

TOOLS REQUIRED

Nissan Rogue 2011-up

99-7611

B CA

• A) Radio Housing • B) Radio Housing Brackets • C) DDIN Trim Plate

KIT FEATURES

KIT COMPONENTS

• ISO DIN head unit provision with pocket

• DDIN head unit provisions

Summary of content (8 pages)

PAGE 1
INSTALLATION INSTRUCTIONS FOR PART 99-7611 APPLICATIONS Nissan Rogue 2011-up 99-7611 KIT FEATURES • ISO DIN head unit provision with pocket • DDIN head unit provisions KIT COMPONENTS • A) Radio Housing • B) Radio Housing Brackets • C) DDIN Trim Plate A B C WIRING & ANTENNA CONNECTIONS (Sold Separately) Wiring Harness: • 70-7552 - Nissan harness 2010-up Antenna Adapter: • 40-NI12 - Nissan antenna adapter 2010-up TOOLS REQUIRED Panel Removal Tool • Phillips Screwdriver • Socket Wrench METRA.
PAGE 2
99-7611 Table of Contents Dash Disassembly – Nissan Rogue 2011-up 3 Kit Assembly – ISO DIN head unit provision with pocket – DDIN head unit provisions 4 5 Caution Metra recommends disconnecting the negative battery terminal before beginning any installation. All accessories, switches, and especially air bag indicator lights must be plugged in before reconnecting the battery or cycling the ignition. *NOTE: Refer also to the instructions included with the aftermarket radio.
PAGE 3
99-7611 Dash Disassembly 1. If equipped with center speaker: Unclip and remove the grille then remove (4) Phillips screws to remove the speaker. (Figure A) 2. Unclip and remove the panel below the radio including the a/c controls. (Figure B) 3. Unclip the radio trim including the a/c vents then unplug the hazard switch and remove the panel. (Figure C) 4. Remove (4) Phillips screws securing the radio.
PAGE 4
Kit Assembly 99-7611 ISO DIN head unit provision with pocket 1. Locate the factory wiring harness in the dash. Metra recommends using the proper mating adapter from Metra or AXXESS. Re-connect the negative battery terminal and test the unit for proper operation. 2. Snap the radio housing brackets to the radio housing. (Figure A) 3. Slide the head unit into the radio opening (from behind) and secure with the screws supplied with the unit. (Figure B) (Figure A) 4.
PAGE 5
Kit Assembly 99-7611 DDIN head unit provisions 1. Locate the factory wiring harness in the dash. Metra recommends using the proper mating adapter from Metra or AXXESS. Re-connect the negative battery terminal and test the unit for proper operation. 2. Mount the radio housing brackets to the sides of the double DIN radio using screws supplied with the double DIN radio. (Figure A) 3. Place the DDIN trim plate on the front of the DDIN radio. (Figure B) (Figure A) 4.
PAGE 6
Notes
PAGE 7
Notes
PAGE 8
REV. 8/08/11 INSTALLATION INSTRUCTIONS FOR PART 99-7611 METRA. THE WORLD’S BEST KITS.™ metraonline.