Installation instructions

ManualsBrandsMetra ManualsMobile PhonesDash kit

INSTALLATION INSTRUCTIONS FOR PART 99-7339

APPLICATIONS

HYUNDAI GENESIS COUPE 2.0

2010-UP

KIT FEATURES

• ISO Head Unit Provision with Pocket

• Painted to match factory finish

99-7339B=Black 99-7339S=Silver

A) Trim Panel B) ISO Brackets C) Pocket D) (6) PC-7503 Panel Clips E) (4) 3/8” Phillips Screws

KIT COMPONENTS

AB C D

TOOLS REQUIRED:

Small Flat Blade Screwdriver • Phillips Screwdriver

Panel Removal Tool • Socket Wrench

1-800-221-0932

www.metraonline.com

99-7339B

99-7339S

METRA. THE WORLD’S BEST KITS.™

WIRING AND ANTENNA CONNECTIONS (Sold Separately)

Wiring Harness:

• 70-7303 - Kia/Hyundai Harness 2009 -up

Antenna Adapter:

• 40-KI11 - Kia/Hyundai Antenna Adapter 2007-up

Summary of content (8 pages)

PAGE 1
INSTALLATION INSTRUCTIONS FOR PART 99-7339 APPLICATIONS HYUNDAI GENESIS COUPE 2.
PAGE 2
99-7339 TABLE OF CONTENTS Dash Disassembly - Hyundai Genesis Coupe 2010-up . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Kit Preparation - Hyundai Genesis Coupe 2010-up . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Kit Assembly - ISO DIN Head Unit Provision . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 *Note: Refer also to the instructions included with the aftermarket radio.
PAGE 3
99-7339 DASH DISASSEMBLY HYUNDAI GENESIS COUPE 2010-UP A 1 Disconnect the negative battery terminal to prevent an accidental short circuit. 2 Unclip and remove the shifter trim panel. (Figure A) 3 Unclip and remove the radio/climate control trim panel. (Figure B) 4 Unclip and remove the display trim panel above radio. (Figure C) B 5 Remove (4) Phillips screws securing the radio. 6 Remove (4) Phillips screws securing the climate control to the factory trim panel.
PAGE 4
99-7339 KIT PREPARATION KIT PREPARATION HYUNDAI GENESIS COUPE 2010-UP A 1 Attach the climate control to the 95-7336S trim plate using the factory hardware. (Figure A) 2 Attach the (6) panel clips to the 95-7336S trim plate.
PAGE 5
99-7339 KIT ASSEMBLY HYUNDAI GENESIS COUPE 2010-UP ISO DIN HEAD UNIT PROVISION A 1 Locate the factory wiring harness in the dash. Metra recommends using the proper mating adapter from Metra or AXXESS. Re-connect the negative battery terminal and test the unit for proper operation. 2 Attach the ISO brackets to the aftermarket radio (figure A), then secure the assembly to the pocket using the (4) supplied Phillips screws (figure B). 3 Mount the assembly into the sub dash.
PAGE 6
99-7339 NOTES
PAGE 7
99-7339 NOTES
PAGE 8
99-7339 INSTRUCTIONS METRA. THE WORLD’S BEST KITS.™ 1-800-221-0932 www.metraonline.com REV.