Owner's Manual

If equipped, there Is a 3-position or a
4-positlon drive position switch. Remove
switches from factory dash panel:
4. Remove 4wd knob from front.
(Figure D)
5. (2) 5.5mm screws from the switch .
(Figure D)
6. Grind down 3 tabs to remove the light
pipe cover and drive position graphic
with icons. Note: Be careful not to
cut into the factory drive position
graphic, it will be re -used along with
the factory light pipe. (clear plastic)
(Figure E)
7. Carefully remove the drive position
graphic. (Figure E)
8. If equipped, remove the factory
passenger airbag indicator and switch.
(Figure F)
Continue to Kit Preparation
DASH DISASSEMBLY (CONT.)
(Figure D) (Figure E) (Figure F)
REV . 7/13/2021 INSTDP-5859 El