Owner's Manual

If equipped with the factory drive
position switch:
1. Snap the drive position switch panel
into place and secure with (2) factory
screws (extra hardware is provided if
needed). (Figure A)
2. Place the graphic into the drive position
switch panel (either 3 position or 4
position). (Figure B)
3. Place the factory light pipe (clear plastic)
into position and then the back cover.
(Figure()
4. Secure the switch with the remaining
factory screws ( extra hardware is
provided if needed) Install the knob
from the front. (Figure D)
II Melra >
(Figure A)
(Figure B)
(Figure C)
KIT PREPARATION
· "'
~.... ··: >
- -
- --
If equipped with the factory passenger
airbag switch:
1. Snap the airbag switch panel into place
and secure with the factory hardware
( extra hardware is provided if needed).
(Figure E)
2. Secure the factory switch into place
using the factory hardware. (extra
hardware is provided if needed).
(Figure F)
Continued on the next page
(Figure D)
(Figure E)
_,,.
-- ~ -:: ✓
...... ____ ::"
__ ;-:; ::--·
--
(Figure F)
386.257.1187 I MetraOnline.com