Owner's Manual

From the factory radio assembly:
1. Unclip and remove center air vents to
reveal (2) screws at the top of the radio
trim panel. Remove the (2) screws .
(Figure F)
2. Unplug and remove the radio trim
panel. (Figure G)
3. Remove the (4) Phillips screws and pull
out the radio assembly. (Figure H)
(Fi gure F)
( Fig ure G)
(Fig u re H)
DASH DISASSEMBLY (CONT.)
4. Remove (2) Phillips screws f rom the
support bar on top of rad io trim. Sav e
bar for kit preparation. (Fi gu re I)
5. Remove (2 ) Phillips screws to remove
the hazard sw i tch. Save switch for
kit preparation . (Figure J)
6. Remove (1) screw from each ai r vent
retaining clip . Keep together for
(Figure I)
kit preparation. ( Figure K)
C ont i nue to Kit Pr eparat ion
(FigureJ)
(Figure K)
REV. 8/26/2021 INSTDP-7528 B