Installation Instructions

ManualsBrandsMetra ManualsAudioDodge Ram 1998-2002 Dash Panel Kit

Metra. The World’s Best Kits.

INSTALLATION INSTRUCTIONS

DP-6551

Attention! Let the vehicle sit with the key

out of the ignition for a few minutes before

removing the factory radio. When testing the

aftermarket equipment, ensure that all factory

equipment is connected before cycling the

key to ignition.

KIT COMPONENTS

• A) Replacement dash panel • B) Radio brackets • C) Retainers • D) #8 x 1/4 “ Phillips screws (4) • E) Panel clips (12)

KIT FEATURES

• ISO DDIN radio provision

• Custom textured dash panel with a DDIN radio opening.

Dodge Ram 1500 1998-2001/

Dodge Ram 2500/3500 1998-2002

Visit MetraOnline.com for more detailed information about the product and up-to-date vehicle

speciﬁc applications

Not designed for 1998 models with single knob headlamp switch or

12 volt power outlet in upper right corner of the dash

TOOLS REQUIRED

• Panel removal tool • Phillips screwdriver

• 3/8” Socket wrench • Cutting tool • Scribe tool

TABLE OF CONTENTS

Dash Disassembly ..................................................2

Kit Preparation .......................................................2

Kit Assembly ..........................................................3

WIRING & ANTENNA CONNECTIONS

(sold separately)

Wiring Harness: 70-1817

Antenna Adapter: Not required

A B C D E

Summary of content (4 pages)

PAGE 1
DP-6551 I N S TA L L AT I O N I N S T R U C T I O N S Dodge Ram 1500 1998-2001/ Dodge Ram 2500/3500 1998-2002 Visit MetraOnline.com for more detailed information about the product and up-to-date vehicle specific applications Not designed for 1998 models with single knob headlamp switch or 12 volt power outlet in upper right corner of the dash KIT FEATURES • ISO DDIN radio provision • Custom textured dash panel with a DDIN radio opening.
PAGE 2
DASH DISASSEMBLY 1. Unclip, unplug and remove the dashboard trim panel. (Figure A) KIT PREPARATION 1. Cut or grind the plastic welds from the rubber trim around the steering column area of the factory dash panel. 2. Remove (2) 3/8” hex-head screws securing the radio to the dash. Slide the radio out, then unplug and remove 2. Secure the factory rubber trim to the replacement dash panel with the supplied retainers and screws. Continue to Kit Preparation 3.
PAGE 3
KIT ASSEMBLY 1. Secure the radio brackets to the radio using the screws supplied with the radio. (Figure A) 2. Locate the factory wiring harness and antenna connector in the dash and complete all necessary connections to the radio. Metra recommends using the proper mating adapter from Metra and/or Axxess. Test the radio for proper operation. 3. Secure the radio assembly to the dash using the factory screws. 4. Reassemble the dash in reverse order of disassembly to complete the installation. (Figure A) REV.
PAGE 4
DP-6551 I N S TA L L AT I O N I N S T R U C T I O N S Having difficulties? We’re here to help. Contact our Tech Support line at: 386-257-1187 Or via email at: techsupport@metra-autosound.com Tech Support Hours (Eastern Standard Time) Monday - Friday: 9:00 AM - 7:00 PM Saturday: 10:00 AM - 7:00 PM Sunday: 10:00 AM - 4:00 PM ® KNOWLEDGE IS POWER Enhance your installation and fabrication skills by enrolling in the most recognized and respected mobile electronics school in our industry. Log onto www.