Owner's Manual

Revision 09/15/94

120 E4900

Receiver Wiring Adaptor

Isolate and individually

tape off the ends of any

unused wires to prevent

electrical short circuit.

How to connect wires:

• Strip wire ends back 1/2"

• Twist together

• Solder

• Tape

Tools required:

soldering iron

solder

(Rosin Core sugg.)

electrical tape

Note: Connect wires to new receiver as indicated, however, if new receiver does not

require separate illumination, isolate and tape off orange wire.

Blue- - Power antenna

Black - Chassis ground

Red - 12 volt switched power

Orange - Illumination

Connect blue wire to power

antenna wire of new receiver.

(Connect black wire to vehicle chassis)