Installation Instructions

3
REV. 9/16/2019 INSTHDCC-02
CONNECTIONS
For models with a factory amp:
From the HDCC-02 harness to the aftermarket radio
Main harness:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Red wire to the accessory wire.
• Connect the Blue/White wire to the amp turn-on wire.
• Connect the White RCA jack to the front left RCA output.
• Connect the Gray RCA jack to the front right RCA output.
• Connect the Green RCA jack to the rear left RCA output.
• Connect the Purple RCA jack to the rear right RCA output.
16-pin harness:
• Connect the Orange/White wire to the illumination wire.
The following (3) wires are for aftermarket multimedia/navigation radios that require these wires:
• Connect the Light Green wire to the parking brake wire (if applicable).
• Connect the Blue/Pink wire to the speed sense wire (if applicable).
• Connect the Green/Purple wire to the reverse wire (if applicable).
• Connect the Yellow RCA jack to the backup camera input.
Note: This RCA jack is used to retain the backup camera as well as the LaneWatch camera.
• Connect the White and Red RCA jacks to the audio AUX-IN jacks (if applicable).
8-pin harness:
• Connect the White RCA jack to the subwoofer output jack.
12-pin pre-wired ASWC-1 harness & 3.5mm jack:
• This harness and 3.5mm jack is to be used along with the optional ASWC-1 (sold separately) to
retain steering wheel audio controls. If the ASWC-1 is not being used, disregard this harness. If
it will be used, refer to the vehicle specific ASWC-1 instruction from Axxess Interfaces for radio
connections and programming. Disregard the harness that comes with the ASWC-1.
• The Gray/Blue wire will only be used in vehicles equipped with Bluetooth. Connect this wire
to the Yellow wire in pin-15 from the 32-pin harness in the factory Bluetooth module.
Bluetooth module location:
Civic - Behind glovebox
CR-V - In dash, under radio
Continue to Installation