RGB Chasing Setup Guide

Heise Application Setup
SINGLE controller, MULTIPLE product configuration
MetraOnline.com
Date: 4/15/2022
One controller, Multiple chasing lighting products
1) Look up all the chasing product being controlled by this
controller in the Pixel count chart. Of the products that are
being controlled, record the highest pixel count.
a. This will calibrate the controller for the largest lighting product
connected. The smaller lighting products that are also connected to
the controller will complete the pattern cycle sooner, then wait for
the larger product to complete the cycle. Once all products
complete the pattern cycle, all products will start the next cycle at
the same time.
2) Set the “Pixel” count to the value found in the previous step
3) Click the green “Setting” button to save.
4) Click the back “<“ in the top left corner to return to the main
app
5) Power cycle the controller, by turning off the power source,
then back on again
6) Test functionality
Example used: HE-CHASE-W17 with HE-CHASE-4KT