RGB Chasing Setup Guide

Heise Application Setup
MULTIPLE controller, MULTIPLE product configuration
MetraOnline.com
Date: 4/15/2022
For Multiple controllers with Multiple lighting product(s)
1) Look up all the chasing product being controlled by all controllers
in the Pixel count chart. Of the products that are being controlled,
record the highest pixel count.
a. This will calibrate the controllers for the largest lighting product’s timing.
The smaller lighting products on the other controllers will complete the
pattern cycle sooner, then wait for the larger product to complete the
cycle. Once all products complete the pattern cycle, all products, on all
controllers, will start the next cycle at the same time. Click the green
“Setting” button to save.
2) Return to the setting screen by clicking “Chasing Settings” from
the pop-out menu again.
3) Scroll the “scroll to choice device” at the top of the screen to
located the next controller that needs to be calibrated.
4) Verify the “RGB Signal Sequence” is set to “RGB”, and set the pixel
count to the same value as the previous controller.
5) Click the green “Setting” button to save.
6) Repeat steps 2-5 for all remaining controllers.
7) Click the back “<“ in the top left corner to return to the main app.
8) Power cycle the controllers, by turning off the power source, then
back on again.
9) Test functionality
Example used: HE-CHASE-W17 with HE-CHASE-4KT