Installation Guide
Tech Support: 386-257-1187
www.HeiseLED.com
460 Walker Street, Holly Hill, FL 32117
HE-CHASE-4KT/8KT
Back of mounting pod
has 3 cable routing
options
Curved mounting pod for
installation on the tubular
frame
Flat mounting pod
M
ounting:
LED rock light
Rubber mounting
P
RO RGB co
n
t
ro
l
l
e
r
RF remote
Contents:
HE-CHASE-4KT
HE-CHASE-8KT
Installation Instructions
Review the vehicle and locate suitable places to mount the LED rock
lights. Avoid locations that are hot, move, pinch points, the gas tank,
and gas lines.
1) Each rock light will have mounting hardware options for both flat
and curved surfaces
2) Using the appropriate mounting base, mount the rock light to a
safe and secure location.
3) Route the cable from the rock light back to the pro controller,
avoiding the locations previously mentioned. Secure the cable
every 12 inches or as necessary.
4) The controller has a left and a right channel. Connect the rock
light cable to the appropriate channel.
5) Repeat the process for the remaining rock lights
6) Mount the pro controller, then make the following connections:
Red: Switched +12v (use an in-line 10A fuse to protect the
circuit)
Black: Chassis Ground
Green: Driver turn signal (+12v)
Yellow: Passenger turn signal (+12v)
White: Brake wire (+12v)
7) Download app. Test functionality with remote and app. Test
turn signals and brake functions.