Heise Application Setup RGB PRO Chasing Configuration Setting up the pixel count in the app is an important step in achieving proper functionality of the chasing RGB lights. Each chasing product has its own unique minimum pixel count determined by the physical properties of the lights. By setting the pixel count in the app, the app effectively knows how large the light (or light set) is and adjust the pattern program accordingly to fit.
Heise Application Setup RGB PRO Chasing Configuration Configuration continued 1) Scroll the “scroll to choice device” at the top of the screen to located the controller that needs to be calibrated. 2) Verify the “RGB Signal Sequence” is set to “RGB”. MetraOnline.
Heise Application Setup SINGLE product configuration One controller and One lighting product 1) Look up the chasing product being controlled by this controller in the Pixel count chart, and find the corresponding pixel count value. 2) Set the “Pixel” count to the value found in the previous step. 3) Click the green “Setting” button to save 4) Click the back “<“ in the top left corner to return to the main app. 5) Power cycle the controller, by turning off the power source, then back on again.
Heise Application Setup SINGLE controller, MULTIPLE product configuration One controller, Multiple chasing lighting products 1) Look up all the chasing product being controlled by this controller in the Pixel count chart. Of the products that are being controlled, record the highest pixel count. a. 2) 3) 4) 5) 6) This will calibrate the controller for the largest lighting product connected.
Heise Application Setup MULTIPLE controller, MULTIPLE product configuration For Multiple controllers with Multiple lighting product(s) 1) Look up all the chasing product being controlled by all controllers in the Pixel count chart. Of the products that are being controlled, record the highest pixel count. a. 2) 3) 4) 5) This will calibrate the controllers for the largest lighting product’s timing.
Heise Application Setup ADVANCED configuration NOTICE: Tech support is unable to assist with ADVANCED configuration setup. Time can be configured so that secondary controllers run multiple cycles in the same time the primary controller completes a single cycle. By setting the controller of the light with the highest pixel count (the primary controller) to a number that is evenly divisible by 2, and is equal to, or greater than that light’s default pixel count (shown in the pixel count chart).
Heise TROUBLESHOOTING RGB PRO techTIP Changing Blue and Green sequence 1) Scroll the “scroll to choice device” at the top of the screen to located the controller that needs to be calibrated. 2) Verify the “RGB Signal Sequence” is set to “RGB”. 3) Click the green “Setting” button to save. 1) There are 2 options for the “RGB Signal Sequence” “RGB” and “RBG”. The “RBG” setting inverts the program sequencing for the blue and green color signals.
