Wiring Instruction Guide

Tech Support: 386-257-1187
www.HeiseLED.com
460 Walker Street, Holly Hill, FL 32117
Installation Instructions
An optional override switch (not included) can be installed, to allow the user to deactivate the controller as
needed.
1) Locate a suitable mounting location for a latched switch, and install the switch. (recommended part# IBRSS)
2) Connect 16ga primary wire (recommended part# PWRD16500) to the red wire of the controller, and route the
primary wire to the switch. Install a female quick disconnect connector (recommended part# BNFD110F) to
the loose end of the primary wire. Push the quick disconnect connector onto either terminal of the switch.
3) Install a female quick disconnect on to a second 16ga primary wire, then push the connector onto the other
terminal of the switch.
4) Run the second primary wire to the switched +12VDC power source. It is recommended to install a fuse
holder and 10A fuse (recommended part# ATFH16C-10 and ATC10-25) between the second primary wire
and the power source. The in-line fuse holder should be no more that 6 inches from the power source.
Override Switch Option
+12VDC
(Switched power source)
Chassis Ground
Latching Switch
(InstallBay# IBRSS)
Heise Pro Controller