Instruction Manual

PRO

SERIES

LED BULB MANUAL

SINGLE DUAL HID

Apply double sided tape

386.257.2956 • HeiseLED.com

*Lock mechanism may be different depending on model

Remove factory bulb

Install new bulb

Make connection

NOTE: Some vehicles may require a Canbus

adapter to stop flashing/pulsating of bulbs

or a lamp out messages in the instrument

cluster. These can be purchased separately

at your local Heise retailer.

PAGE 1
PRO SERIES LED BULB MANUAL SINGLE DUAL Remove factory bulb HID Install new bulb 1 *Lock mechanism may be different depending on model Apply double sided tape 2 3 Make connection NOTE: Some vehicles may require a Canbus adapter to stop flashing/pulsating of bulbs or a lamp out messages in the instrument cluster. These can be purchased separately at your local Heise retailer. 386.257.2956 • HeiseLED.
PAGE 2
PATTERN ADJUSTMENT (1) Loosen the set screw just enough so that the bulb can be rotated *some models do not have a set screw (2) Set vehicle on a level surface, 10 feet back from a wall or garage door 10 ft (3) Turn the bulb and watch the pattern on the wall change. (5) Re-tighten the set screw Keep your original factory bulbs so that you can replace them for use on public roads.