Installation Instructions

Replacement Smoked Side Markers

for JEEP WRANGLERS

HE-JWSSM

(Smoked Side Markers)

Applications: 2007-Current

Jeep Wranglers

Tools Needed – Flat Head Screwdriver

Instructions:

1. Remove the two push pins on the side of the fender

near the side marker light.

2. Unplug the original side marker light and remove the

OEM bulb.

3. To remove side marker light, pull the fender out

towards you while at the same time pushing down on

the clip located on the top of the light.

4. Remove the original side marker light.

PAGE 1
Replacement Smoked Side Markers for JEEP WRANGLERS HE-JWSSM (Smoked Side Markers) Applications: 2007-Current Jeep Wranglers Tools Needed – Flat Head Screwdriver Instructions: 1. Remove the two push pins on the side of the fender near the side marker light. 2. Unplug the original side marker light and remove the OEM bulb. 3. To remove side marker light, pull the fender out towards you while at the same time pushing down on the clip located on the top of the light. 4. Remove the original side marker light.
PAGE 2
5. Insert the new HEISE LED side marker light by putting the bottom hooks in before snapping the top clip into place. 6. Plug OEM harness into the new light. 7. Align the fender back and reinsert the two push pins previously removed to secure the fender back in place. Specifications: (8) 2835 LEDs for a total of 4 watts LED color: 2000K DOT approved for on-road use Plugs into OEM Harness Dust/Water resistance: IP67 1-800-221-0932 www.HeiseLED.