Installation Guide

REV. 06/18/2021 INSTJP-JTKT
5
Figure A Figure B
CAMERA ASSEMBLY
1. Place the wire from the aftermarket
camera through the hole between the
numbers and the arrow.
2. Keep the orienitation correct as to not
mount the camera incorrectly. The top
of the factory housing is the longer part
of the housing. The top of the camera is
indicated by the QC sticker and the top
of the bracket is indicated by the arrow
pointing towards the top of the factory
housing.
3. Place the camera in the bracket by
running the wire through the slot and
line up the mounting locations on the
bracket to the factory housing.
4. Replace the 3 factory screws. The
positions differ depending on the factory
backup camera (Figure A) or surround
view or 360 camera (Figure B).