Installation Guide

386-257-1187
|
Metraonline.com
6
1. Re-assemble the camera into the tailgate.
2. Run the wire, following the old camera
wiring from the tailgate to the truck bed.
(Figure A)
3. Once inside the vehicle, you can power
the camera via a reverse trigger from the
taillight. Connect the RED wire to the reverse
trigger. Connect the BLACK wire to a chassis
ground. The RED wire is also located at the
opposite end of the harness with the YELLOW
RCA if the user wants the camera powered
with an accessory circuit.
4. Run the wire down the length of the vehicle
carefully. Make sure not to run near any
objects that can cause extreme heat or catch
the wire. (Figure B)
5. Connect the YELLOW RCA to the aftermarket
radio. There is a Red wire with the RCA, this
can be used in two ways. This wire can bring
a reverse trigger to the front of the vehicle
if the camera is powered in the rear. This
can also be used to power the camera in the
front if the camera is desired to be powered
via an accessory circuit.
Figure A Figure B
WIRING