Installation Instructions

1.800.221.0932
|
iBEAMUSA.com
2
Camera Wiring/Install (Figure A)
1. Find a desirable location to mount the
camera. Make sure this location is away
from moving objects and has a clear
visual of the desired view wanted from
the camera.
2. Drill a 8 mm size hole for the bolt and
wiring to be ran into the vehicle. Secure
the camera with the provided nut.
3. Connect the wires to the designated
sources below. Verify with a multi-meter
that the correct wire is being used
• RED wire to 12V reverse or accessory
if desired
• BLACK wire to chassis ground
4. Run the extention wire to the location
where the visual will be displayed, ex.
aftermarket radio or monitor.
5. There are two loops located on the
camera wire.
• GREEN loop - Parking lines on/off
• BROWN loop - Mirror/normal image
NOTE: Figure B shows adjustablity of camera.
(Figure A)
(Figure B)
WIRING/INSTALL