Installation Guide

386-257-1187
|
iBEAMUSA.com
4
Figure A
GROUND
10-20 in 10-20 in
15-24 in 15-24 in
1
2
2
Mounting of Sensors (Figure A)
NOTE: This installation may require the removing
of the bumper to get the proper sensor alignment.
1. Using the painters tape on the outside of the
bumper as a guide, re-measure the desired
sensor location on the inside of the bumper.
• 10-20 inches from the bumper center
• 15-24 inches from the ground
NOTE: Measurements do depend on the vehicles
itself. There is a 4 inch tolerance on the mea-
surements listed, but measurements can vary by
vehicle. For example, a SUV may have a higher
measurement from the ground.
2. Clean the surface thoroughly where the
sensors will be mounted on the inside of the
bumper. Some dirt may cause the sensors to
give false alerts.
3. Remove the backing from the 3M double
sided tape and use the provided adhesion
promotor to assist in improving the adhesion
to the bumper. Mount the sensors with the
connector side mounting down towards the
ground. Make sure the sensors are as straight
as possible to each other and on the flatest
surface possible on the bumper.
I N STALL ATI ON