Installation Guide

REV. 04/18/2022 INSTTE-2PSK
5
Figure A
Running the wiring
1. Carefully find a safe location to run the
wires along the bumper or underside of
the bumper on the vehile. Use zip ties to
secure the wiring to the vehicle. Please keep
away from moving parts and anything that
would cause too much heat near the wiring.
(Figure A)
2. Find a suitable location to gain access to the
inside of the vehicle.
3. Mount the Audible buzzer inside the vehicle
in a good loction that the driver will hear
the alerts clearly. The wires may need to be
extended is the location is desired near the
front of the vehicle.
4. Remove the double sided tape and mount
to a flat surface. If needed the adhesion
promotor can be used here also. (Figure B)
5. \ Plug the buzzer in. Please keep the
connector next to the buzzer avaialble. This
is for the calibration button which is used
in the next step. This button does NOT need
to remain plugged in after calibration is
finished.
Figure B
I N STALL ATI ON