Installation Guide

386-257-1187
|
iBEAMUSA.com
6
Figure AFigure A
CALIB R ATI O N
Calibration
1. Complete the installation, put the bumper
back in place, make sure power and ground
are connected and the buzzer is plugged in.
Connect the provided push button to the
harness near the buzzer connection.
2. Check power up and make sure there are no
moving object within 3 feet of the rear of the
vehicle. (Figure A)
3. Press and hold the calibration button for
more than 3 seconds to activate the parking
sensor system. You should hear two continu-
ous beeps. If not please repeat step 3.
4. Check function of the parking sensors.
5. There should be 3 zones of alerts
• Level 1: 3.2 FT to 2 FT - slow beeping
• Level 2: 2 FT to 1 FT - faster beeping
• Level 3: less than 1 FT - constant beeping
3 FT
> 1 FT
1 - 2 FT
2 - 3.2 FT