Product Manual

1. Find a suitable location to surface mount install the camera. Make sure the
came
ra’s view is unobstructed and be careful not to drill into any wires that
might damage the vehicle. When all connections have been made and before
mounting the camera, verify the camera is working and has good view of the
area. Then mount the camera down with the supplied two screws.
2. Connect the RED wire to the +12 volt reverse wire
Note: Power ca
n
a
lso be obtained in the rear of the vehicle using the
BLUE power
wire provided on the extension cable. If this is done, connect
the RED and the BLUE wire closest to the RCA together. The blue wire is
just a pass-through, RED must be connected to power the camera.
3. Connect the BLACK w
ire to ground (a metal, non-painted surface).
4. Run video cable though vehicle, up to video display. (Avoid placing video
cable where it can get pinched or damaged).
5. Attach the YELLOW video RCA to camera’s output and to the reverse camera
input of the radio or video display.
Loop cutting Instructions:
Green loop will turn the parking guidelines off
Copper loop will mirror the image