Owner's Manual

ManualsBrandsMetra ManualsATV & UTVAxxess Interface Harness

Table Of Contents

Installation Instructions

CAUTION!

All accessories, switches, climate

controls panels, and especially air bag indicator

lights must be connected before cycling the

ignition. Also, do not remove the factory radio

with the key in the on position, or while the

vehicle is running.

XSVI-9701-NAV

INSTALLATION INSTRUCTIONS

INTERFACE FEATURES

INTERFACE COMPONENTS

TOOLS REQUIRED

• Wire cutter • Crimp tool • Solder gun • Tape

• Connectors (example: butt-connectors, bell

caps, etc.)

TABLE OF CONTENTS

Connections to be made .......................................2

Installing the XSVI-9701-NAV ................................3

Polaris Slingshot Data Interface 2015-up*

• Provides NAV outputs (parking brake, reverse, speed sense)

• Retains the factory USB

• Pre-wired ASWC-1 harness (ASWC-1 sold separately) *

• Retains balance and fade

• Micro “B” USB updatable

• XSVI-9701-NAV interface

• XSVI-9701-NAV harness

*Visit AxxessInterfaces.com for up-to-date vehicle speciﬁc applications.

* For retention of Speed Dependent Volume Control only

Summary of content (4 pages)

PAGE 1
XSVI-9701-NAV I N S TA L L AT I O N I N S T R U C T I O N S TABLE OF CONTENTS Connections to be made .......................................2 Installing the XSVI-9701-NAV ................................3 Polaris Slingshot Data Interface 2015-up* *Visit AxxessInterfaces.com for up-to-date vehicle speciﬁc applications.
PAGE 2
CONNECTIONS TO BE MADE From the XSVI-9701-NAV harness to the aftermarket radio: • Connect the Black wire to the ground wire. • Connect the Yellow wire to the battery wire. • Connect the Red wire to the accessory wire. • Connect the Gray wire to the right front positive speaker output. • Connect the Gray/Black wire to the right front negative speaker output. • Connect the White wire to the left front positive speaker output. • Connect the White/Black wire to the left front negative speaker output.
PAGE 3
INSTALLING THE XSVI-9701-NAV With the key in the off position: • Connect the XSVI-9701-NAV harness into the interface, and then to the wiring harness in the vehicle. • If installing an ASWC-1 (sold separately), connect it after you test the XSVI-9701-NAV, with the key in the off position. • Turn the key to the accessory position and test all functions of the installation for proper operation, before reassembling the dash. REV.
PAGE 4
XSVI-9701-NAV I N S TA L L AT I O N I N S T R U C T I O N S IMPORTANT If you are having difﬁculties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated. Please have the vehicle apart and ready to perform troubleshooting steps before calling.