User manual

MD 1060, MD 1160
10
7.4 Continuity test
Make sure the object under test isn’t live.
• Connect both test probes to the object under test. Continuity LED lights up and buzzer
sounds continuously to indicate continuity
7.5 Torch light
• Pressing the torch light button to turn on the light and after approx. 10s it will turn itself off
8. Battery Replacement
Remove the probes from any testing point, when opening the Battery case. Batteries are
dead when the continuity test with both test probes connected cannot be done anymore. A
battery symbol in the LCD indicates low battery.
Follow the procedure below and replace batteries with new ones (type IEC LR03 1.5V).
• Unscrew the battery door, e.g. with a coin.
• Pull out the Battery door and replace the batteries. Insert new batteries according to the
engraving on the Battery door.
• Re-assemble battery door.
Confirm that the Battery door case is properly locked prior to measurements.