Operation Manual

OmegaGTPlus / BetaGTPlus Main menu and test modes
15
3 Main menu and test modes
The OmegaGTPlus / BetaGTPlus instrument has a user-friendly manipulation. Most of
the actions can be done by using only few keys. Menu tree of the instrument is simple to
understand and easy to operate.
From the Main menu different instrument operation modes can be set:
Ì VDE organizer (see 3.1),
Ì Custom autotest (see 3.2),
Ì Project autotests (see 3.3),
Ì Barcodes / RFID tags (see 3.4),
Ì Single test menu (see
3.5),
Ì Modifying data for tested equipment
(see
3.6)
Ì Memory operations (see 3.7),
Ì Data transfer (see 3.8) and
Ì Settings (see 3.9).
Main menu
Keys:
À / ¿
Select the operating mode.
ENTER
Enters selected mode.
After the instrument is switched on, the last accessed menu will be displayed.
Main feature of the instrument are Autotests that can be accessed through three
mentioned possibilities:
Ì VDE Organizer (see 3.1),
Ì Custom autotest (see 3.2), and
Ì Project autotest (see 3.3).
Autotest is the fastest and easiest way to test appliances. A pre-programmed autotest
sequence runs all the tests needed to verify the selected appliance. Complete autotest
results can be stored together with appliance name and all belonging information.
Note:
Ì Press ESC key one or more times to return to Main menu from any submenu or
selected function
3.1 VDE organizer
This menu offers selection and performing of VDE compatible test sequence. The
sequence setup and its parameters are exactly the same as suggested in the
VDE701/702 standards.
Following actions can be taken after entering the VDE organizer menu: