Operation Manual

OmegaGTPlus / BetaGTPlus Main menu and test modes
27
F4 (EDIT)
Opens menu for modifying parameters of selected test function.
¿ / À
Select test function in the sequence.
START
Starts running the selected function. See chapter 3.1.3 Performing
autotest sequences.
ESC
Returns back to custom autotest menu.
Modification of autotest sequence
The key F4 (EDIT) as mentioned above enable to modify selected function.
Modification parameters of selected test function
Keys:
À / ¿
Select the parameter.
½ / ¾
Modify value of selected parameter (highlighted).
F1 (VIEW)
Accepts modified function and returns to the view of selected test
sequence.
ESC
Returns to the view of selected test sequence.
Mode is general parameter of each test function in autotest sequence with the following
possible values: [disabled, single, continuous].
disabled
Test function will not be involved in appliance test, normally it is
not needed.
single
The test function is performed only once per autotest sequence
run.
continuous
Repeated option where the test function could be preformed as
many times as operator needs.
Rest parameters ale directly adjusted to each test function.
3.2.3 Saving custom autotest sequence
Custom autotest sequence can bi saved even if it was or was not modified. There are
two options to save the autotest sequence to the same name or save under new name.
Saving is possible only in the view of selected autotest sequence menu; see chapter
3.2.2 above.