Operation Manual

OmegaGTPlus / BetaGTPlus General description
6
1.1 Warnings
In order to reach high level of operator safety while carrying out various measurements
using OmegaGTPlus / BetaGTPlus instrument, as well as to keep the test equipment
undamaged, it is necessary to consider the following general warnings:
Ì Read this user manual carefully, otherwise use of the instrument may be
dangerous for the operator, for the instrument or for the equipment under
test!
Ì If the test equipment is used in manner not specified in this user manual
the protection provided by the equipment may be impaired!
Ì Use only correctly earthed mains outlets to supply the instrument!
Ì Do not use the instrument and accessories if any damage is noticed!
Ì In case a fuse has blown follow the instructions in this user manual to
replace it!
Ì Instrument servicing and calibration is allowed to be carried out only by a
competent authorized person!
Ì Use only standard or optional test accessory supplied by your distributor!
1.2 Warning markings on connector panel
Refer to chapter 2.1 Front panel!
1.3 Standards applied
The OmegaGTPlus / BetaGTPlus instrument is manufactured and tested according to
the following regulations, listed below.
Electromagnetic compatibility (EMC)
EN 61326
Electrical equipment for measurement, control and laboratory use –
EMC requirements
Class B (Portable equipment used in controlled EM environments)
Safety (LVD)
EN 61010 - 1
Safety requirements for electrical equipment for measurement,
control, and laboratory use – Part 1: General requirements
EN 61010 - 31
Safety requirements for hand-held probe assemblies for electrical
measurement and test