Operation Manual

MI 3309 BT DeltaGT Autotest sequences
60
6.1.1.10 Touch leakage measurement
The measurement is described in chapter 5.2.9 Touch Leakage.
Figure 6.17: VDE Organizer – Touch leakage starting screen
There are no special options in the Touch leakage - starting screen.
Figure 6.18: VDE Organizer – Touch leakage result screen
Options in Touch leakage result screen:
NEXT
Proceeds with the next measurement.
REPEAT
Repeats the test (use in case of multiple isolated / SELV / PELV
accessible points). Highest result will be stored.
6.1.1.11 RCD test
This test is offered if it is applicable according to the VDE Organizer setting.
The measurement is described in chapter 5.2.10 (P)RCD test.
Options in VDE organizer starting screen:
NO
To be set if RCD test is not applicable.
RCD
To be set if RCD test is applicable.
Figure 6.19: VDE Organizer –RCD starting screen
Options in RCD starting screen:
/ 
Sets nominal RCD value
Note:
 The test mode is automatically set to Single test, 1xI
∆N
, both polarities.
Figure 6.20: VDE Organizer –RCD result screen